Bissell Clean Water Reservoir for Cordless Crosswave

Clean Tank w/ Cap CrossWave® Cordless Max

Clean Tank with the Cap for the BISSELL® CrossWave® Cordless Max Multi-Surface Wet/Dry Vac.

To Fill the Clean Water Tank, follow these instructions:

The Clean Water Tank is located on the back of the machine. To remove, use the finger groove above at the top of the tank to grab and pivot the tank backwards
Unscrew the cap from the bottom of the Clean Water Tank
Choose the right BISSELL® formula
The Clean Water tank has a Large Area volume and a Small Area volume. Pick one of the measuring volumes that best suits the space that you would like to clean. The Large Area fill lines are for areas up to 700 sq ft. The Small Area fill lines are for areas under 350 sq. ft
Use warm (140°F/60°C max) tap water and add the appropriate BISSELL formula. Tap water with hardness greater than 35 ppm is recommended for use in machine to ensure the Dirty Water Tank full detection sensor works properly
Screw the cap back on the Clean Water tank. On the back of the machine, align the bottom of the Clean Water Tank with the grooves and pivot the tank until it "clicks" into place

Fits the Following Models:
BISSELL® CrossWave® Cordless Max Multi-Surface Wet Dry Vac
2554A
Similar Models: 25542, 25548, 2593, 2597
BISSELL® CrossWave® Cordless Max Multi-Surface Wet Dry Vac Exclusive Bundle
2596
BISSELL® CrossWave® Cordless Max Multi-Surface Wet Dry Vac
2554
CrossWave® Cordless Max Multi-Surface Wet Dry Vac
CrossWave® Cordless Max Multi-Surface Wet Dry Vac
Model Shown: 2590
CrossWave® Cordless Max Multi-Surface Wet Dry Vac
2596B
CrossWave® Cordless Max Multi-Surface Wet Dry Vac
2596M
BISSELL® CrossWave® Cordless Premier All-In-One Multi-Surface Cleaner
2597